巩义ABA film blowing machine

ABA film blowing machine ABA film blowing machine prompts that during the installation of the film blowing machine, attention should be paid to adjusting the center line of the extruder head and the center of the traction roll to keep horizontal and vertical without deviation and skew. During winding, due to the gradual increase of winding outer diameter, please pay attention to the coordination between traction speed and winding speed, and please adjust it in time. After the main engine is started, pay close attention to the operation of the main engine, and timely adjust, correct, electrical instruments and controllers to ensure their normal operation. The main engine gearbox and traction reduction gearbox shall be frequently refueled and the gear oil shall be replaced. For the new machine, please replace the new gear oil about 10 days after use to ensure the normal operation of all rotating parts. Pay attention to refuelling to prevent jamming and overheating damage. Also, check the fastening of all connecting parts to prevent the bolt from loosening. If the equipment is not heated and the heating temperature and time do not meet the specified requirements, the extruder and rotating die shall not be started, otherwise the equipment will be damaged. The filter screen and corona processor of the extruder must be replaced and cleaned regularly. Generally, it is required to replace the filter screen and clean the silicone roller of the corona processor with alcohol within 24 to 48 hours. Specification of filter screen: two layers of 80 mesh, one layer of 100 mesh and three layers of filter screen.